 |
Texture and movement are the inspiration for this blunt, to-the-shoulder bob. A soft, razor cut fringe frames the eyes while tousled and loose curls are layered throughout for natural volume and an unconstructed look. The Sheer Indulgence monofilament crown provides a natural contour.
KANEKALON VIBRALITE FIBER HAIR CARE INSTRUCTIONS
Important
- Take
special care with lace front wigs and hairpieces. The lace is delicate and
should not be tugged or pulled.
- Sudden
bursts of heat, such as opening an oven door, will damage synthetic fiber.
- We do
not recommend sleeping, showering, or swimming while wearing.
- For
longer styles, comb through nape area often using your fingers or a
wide-tooth comb.
- Never
use thermal styling tools to heat style synthetic fiber. Using a blow
dryer, curling iron, hot rollers, etc. will damage synthetic fiber.
- Hair
color cannot be used on synthetic fiber.
Pre-wash
Gently remove tangles using your fingers or a wide-tooth
comb. (Do not use a brush.) Start at the ends and slowly work toward the base
to avoid damage. Do not overstretch or pull on the fiber.
Wash
- Add 1
tbsp of HairUWear CLEANSE to a washbasin of cool water. Caution:
Hot water will damage synthetic fiber.
- Soak
wig or hairpiece in washbasin for 3-5 minutes. Do not scrunch or
agitate. Caution: Soaking longer than 5 minutes can damage the wig
or hairpiece.
- Rinse
under cool running water until the water runs clear. Use a clean,
colorfast towel to gently press out excess water. Do not twist or wring.
- Apply
a light mist of HairUWear RESTORE and comb through using a wide-tooth
comb starting at the ends. Caution: Do not apply RESTORE
directly to hand-tied areas as this may loosen the knots and cause
shedding.
- For
wavy/curly styles, be careful not to overstretch or pull on the fiber.
- The
damp wig can then be placed on a wig stand to dry. Hairpieces can be
clipped on a hanger to dry, however hand-tied hairpieces should instead
dry flat on a colorfast towel to prevent any damage to the delicate
construction. Caution: Do not dry wig on a solid form or mannequin
head to avoid overstretching the cap.
Styling
- Shake
to release fiber. Style with your fingers to achieve the desired look.
- There
are a variety of styling brushes and combs specially designed
for synthetic wigs and hairpieces.
- HairUWear
offers medium hold and strong hold styling sprays specially
formulated for synthetic fiber.
- For
wavy/curly styles, refresh the texture as needed by spritzing with a 50/50
mix of water and RESTORE while finger-styling.
- Never
use heat-styling tools to style synthetic fiber.
Maintenance
- After
each wearing, gently comb through the wig or hairpiece using your fingers
or a wide-tooth comb.
- Use
HairUWear REFRESH neutralizing spray as needed to extend the
time between washings.
- To
avoid unwanted kinks or crimps, store on a wig stand (or clip
hairpiece on a hanger).
- To
maintain wavy/curly textures, style only when the hair is completely dry
using only your fingers. Do not comb or brush dry hair as this can loosen
the texture.
- After
extended wear, matting and frizzing can occur. To detangle and
recondition: wash as recommended, spray with HairUWear RESTORE, then
comb through with a wide-tooth comb starting at the ends.
|
|
|
Cool style! 
