1. Spray C-22 Solvent on the adhesive area. Remover will begin working almost immediately.
2. Saturating the adhesive area and wiping off the residue once breakdown has occurred will help give the best results. The release time will depend on adhesive buildup.
3. Wipe or brush off the residue from the system. Shampoo and rinse C-22 from unit.

For Solvent Soaks

1. Fill a large bowl or sink with C-22 Solvent.
2. Place the system into the solvent, base side up. Keep the system submerged and work the adhesive build up off.
3. Wear gloves to keep your hands out of direct contact with the solution. Shampoo the system and rinse. Soak times vary from 5-30 minutes, depending on the type of system and adhesive used.

Flammable - do not store or use near heat, sparks, or open flame. Use in a well-ventilated area. Close lid tightly. Do not apply to cut, broken, or irritated skin. External use only, do not ingest. Avoid eye contact. Keep out of reach of children. Test on a small area before use.

Store in a well-ventilated, cool, dark, dry, room-temperature controlled environment (60-80°F). SDS sheet is available below.