Swept Back Short Cut by Hairdo - Heat Friendly Tru2Life Synthetic Hair Wig

Home > Brands
> Hairdo >

Swept Back Short Cut by Hairdo | Heat Friendly Synthetic Wig - Basic Cap

Alternative Views:

List Price: $172.00

Our Price: $146.20

Savings: $25.80

Product Code: HDSWEPTBACKSHORTCUT

		Click to view another Hairdo Colors
Hairdo Colors*:

Qty:

Description

Maintenance

Designed with a stylized wave texture that's been razor cut into multiple layers, this versatile style offers a lot of "play" for a short cut. Fullness at the crown lets you amp up the piecey texture, or wear it smooth and close to the head. Sweep the bangs back or brush forward for a wispy fringe.

Important:

Take special care with lace front wigs & hairpieces. The lace is delicate and should not be tugged or pulled.
Sudden bursts of heat such as opening an oven door, may damage heat-friendly synthetic fiber.
We do not recommend sleeping, showering, or swimming while wearing.
For longer styles, comb through nape area often using your fingers or wide-tooth comb.
Hair color cannot be used on synthetic fiber.

Pre-Wash

Gently remove tangles using your fingers or a wide-tooth comb. (Do not use a brush). Start at the ends and slowly work toward the base to avoid damage. Do not overstretch or pull on the fiber.

Wash/Condition

Add 1 tbsp of shampoo to a washbasin of cool water. (Caution: Hot water will damage synthetic fiber)
Soak wig or hairpiece in wash basin for 3-5 minutes. Do not scrunch or agitate. (Caution: Soaking longer than 5 minutes may damage the wig or hairpiece)
Rinse under cool running water until the water runs clear. Use a clean, colorfast towel to gently press out excess water. Do not twist or wring.
Apply a light mist of spray-on leave-in conditioner and comb through using a wide-tooth comb starting at the ends. (Caution: Do not apply conditioner directly to hand-tied areas as this may loosen the knots and cause shedding)
For wavy/curly styles, be careful not to overstretch or pull on the fiber.
The damp wig can then be placed on a wig stand to dry. Hairpieces can be clipped on a hanger to dry, however hand-tied hairpieces should instead dry flat on a colorfast towel to prevent any damage to the delicate construction. (Caution: Do not dry wig on a solid form or mannequin head to avoid overstretching the cap)

Styling

Shake to release the fiber. Style with your fingers to achieve the desired look.
Tru2Life fiber can be curled, waved, flat-ironed or blown dry to achieve a different texture. Once heat-styled, the wig or hairpiece will keep the new texture even after washing.
Suggestion: Use a light mist of heat-protectant silicone spray prior to heat-styling
Tru2Life fiber can withstand a low-medium heat setting up to 350 degrees F / 180 degrees C (Caution: Fiber will be damaged if the heat setting is too high. Do not heat-style while wearing as heat-friendly synthetic fiber will get very hot.)
To Straighten: take a 1-inch section and run a flat iron from the base to the ends. Allow to cool.
To curl: wrap a 1-inch section around a curling iron and hold for 10 seconds. Carefully slide the iron out and hold the curl shape with a hairpin or clip until completely cool to set the curl.
For wavy/curly styles, refresh the texture as needed by spritzing with 50/50 mix of water and spray-on leave-in conditioner while finger-styling.

Maintenance

After each wearing, gently comb through the wig or hairpiece using your fingers or wide-tooth comb
To avoid unwanted kinks or crimps, store on a wig stand or clip hairpiece to a hanger
To maintain wavy/curly textures, style only when the hair is completely dry using only your fingers. Do not comb or brush dry hair as this can loosen the texture.
After extended wear, matting and frizzing can occur. To detangle and recondition, wash as recommended, spray with leave-in conditioner, then comb through with a wide-tooth comb starting at the ends.

Specifications
Made with Tru2Life® heat-friendly synthetic fiber that looks & feels like real hair. The texture is light, soft, and lustrous without being shiny, plus it's heat-friendly! Straight styles can be curled and curly styles can be straightened using your flat iron, curling iron, or blow dryer.
(Heat-safe to 350 degrees - See packaging insert for complete directions)

Cap Construction: