Important

• Take special care with lace front wigs and hairpieces. The lace is delicate and should not be tugged or pulled.
• Sudden bursts of heat, such as opening an oven door, will damage synthetic fiber.
• We do not recommend sleeping, showering, or swimming while wearing.
• For longer styles, comb through nape area often using your fingers or a wide-tooth comb.
• Never use thermal styling tools to heat style synthetic fiber. Using a blow dryer, curling iron, hot rollers, etc. will damage synthetic fiber.
• Hair color cannot be used on synthetic fiber.

Pre-wash

Gently remove tangles using your fingers or a wide-tooth comb. (Do not use a brush.) Start at the ends and slowly work toward the base to avoid damage. Do not overstretch or pull on the fiber.

Wash

1. Add 1 tbsp of HairUWear CLEANSE to a washbasin of cool water. Caution: Hot water will damage synthetic fiber.
2. Soak wig or hairpiece in washbasin for 3-5 minutes. Do not scrunch or agitate. Caution: Soaking longer than 5 minutes can damage the wig or hairpiece.
3. Rinse under cool running water until the water runs clear. Use a clean, colorfast towel to gently press out excess water. Do not twist or wring.
4. Apply a light mist of HairUWear RESTORE and comb through using a wide-tooth comb starting at the ends. Caution: Do not apply RESTORE directly to hand-tied areas as this may loosen the knots and cause shedding.
5. For wavy/curly styles, be careful not to overstretch or pull on the fiber.
6. The damp wig can then be placed on a wig stand to dry. Hairpieces can be clipped on a hanger to dry, however hand-tied hairpieces should instead dry flat on a colorfast towel to prevent any damage to the delicate construction. Caution: Do not dry wig on a solid form or mannequin head to avoid overstretching the cap.

Styling

• Shake to release fiber. Style with your fingers to achieve the desired look.
• There are a variety of styling brushes and combs specially designed for synthetic wigs and hairpieces.
• HairUWear offers medium hold and strong hold styling sprays specially formulated for synthetic fiber.
• For wavy/curly styles, refresh the texture as needed by spritzing with a 50/50 mix of water and RESTORE while finger-styling.
• Never use heat-styling tools to style synthetic fiber.

Maintenance

• After each wearing, gently comb through the wig or hairpiece using your fingers or a wide-tooth comb.
• Use HairUWear REFRESH neutralizing spray as needed to extend the time between washings.
• To avoid unwanted kinks or crimps, store on a wig stand (or clip hairpiece on a hanger).
• To maintain wavy/curly textures, style only when the hair is completely dry using only your fingers. Do not comb or brush dry hair as this can loosen the texture.
• After extended wear, matting and frizzing can occur. To detangle and recondition: wash as recommended, spray with HairUWear RESTORE, then comb through with a wide-tooth comb starting at the ends